Selection guide
Slitting line or cut-to-length line?
Both lines process coil, but they cut in different directions: one produces strip coils, the other flat sheets. Your output decides the line.
Side-by-side comparison
| Criterion | Coil slitting line | Cut-to-length line |
|---|---|---|
| Cutting direction | Longitudinal — along the strip | Transverse — across the width |
| Output product | Narrow strip coils | Flat sheets cut to size |
| Cutting unit | Circular knife sets | Shear or flying cut |
| End of line | Recoiler and tension system | Stacking unit |
| Typical customer | Roll forming, profile and tube producers | Press shops, laser cutting and sheet fabricators |
Choose a slitting line if
- Your output will be strip in coil form
- You will feed the strips into your own roll forming or tube line
- You want to split wide master coils into ordered widths
Choose a cut-to-length line if
- Your output will be flat sheets at a defined length
- The sheets will feed a press, laser or press brake
- Flatness quality is critical
In short
These are not alternatives to each other — they make different products. If you need both strip and sheet, let us discuss combined lines that do slitting and cut-to-length on one frame.
Go to product pageLet's design a line for your project
Send us your profile drawing or capacity requirements — our engineering team will get back to you within 48 hours.